9.1. Perform FX

CRUSH

Bitcrusher effect. Slide up to decrease the sample rate of the signal.

PITCH

Trigger based pitch shift effect. Slide up from the middle to pitch all pads up. Slide down from the middle to pitch all pads down.

COMB

Comb filter. Slide up for slower delay time.

RING

Ring modulation. Slide up for faster modulation.

REVERB

Stereo reverb effect. Slide up for bigger and longer reverb.

STUTTER

Tempo synced beat repeat effect. Slide up to go from ½ bar to 1/64 bar repeats synced to your song’s tempo.

GATE

Threshold gate effect. Slide up to increase the threshold of audible sound.

FILTER

high pass / low pass resonant filters. Slide up from the middle for a high pass filter. Slide down from the middle for a low pass filter.

CUTTER

Tempo synced gate effect. Slide up for faster muting. 1 bar to 1/64 bar

REVERSE

Reverse effect. Slide up for longer reverse time.

DUB

Dub delay effect. Slide up for slower delay and longer feedback.

TEMPO DELAY

Stereo delay effect. Slide up for a longer delay.

TALKBOX

Talkbox modulation effect. Slide between different vowel modulations.

VIBROFLANGE

Flanger / Wobble effect. Slide above the middle for flanger. Slide below the middle for wobble effect.

DIRTY

Overdrive effect.

COMPRESSOR

One-knob compressor. Higher setting creates more drastic “duck” effect.

9.2. Mixer Effects

Auto pan effect

AUTOPAN

Versatile panning effect.

  • DEPTH: 0.00–100%
  • SPEED: 0.000–30 Hz / 1/64–8 bars
  • STEREO: 0.00–100%
  • WAVEFORM: Sinus, Square, Triangle, Saw, Inverted Saw, Random Square, Random Triangle
  • TEMPO SYNC: on/off

Bandpass effect

BANDPASS

Band pass filter.

  • FREQ: 50–20.0 Hz
  • WIDTH: 0.50–20

Bitcooker effect

BITCOOKER

Bit reduction and sample rate reduction with variable jitter.

  • SAMPLERATE: 800 Hz to 44.000 kHz
  • BIT DEPTH: 3–24 bit
  • JITTER: 0.00–100%
  • MIX: 0.00–100%

Compressor

COMPRESSOR

Compresses the loudness of a signal to make it more uniform in loudness. Can also modify transients.

  • MAKEUP: on/off
  • KNEE/GRAPH: switch between knee indicator and spectrogram
  • THRESHOLD: -42–0.00 dB
  • RATIO: 1.0–100
  • ATTACK: 0.010–30 ms
  • RELEASE: 10.0–1200 ms

Delay effect

DELAY

Filterable, syncable delay.

  • DELAY: 0.00000 ms to 2.50 sec / 1/64–8 bars
  • STEREO: on/off
  • TEMPO SYNC: on/off
  • FREQ: 100 Hz to 8.00 kHz
  • WIDTH: 1.0–20
  • FEEDBACK: 0.00–100%
  • MIX: 0.00–100%

Drive

DRIVE

Basic waveshaping distortion.

  • DRIVE: 0.000–36 dB
  • MIX: 0.00–100%
  • OUT: -90–0 dB

EQ effect

EQ

3-band parametric EQ

  • LOW SHELF/HI PASS: -18–18 dB
  • BELL: -18–18 dB
  • HI SHELF/LOW PASS: -18-18 dB
  • Q: 0.50–10

Filter effect

FILTER

Filter featuring multiple filter types and modulation options.

  • FILTER TYPE: Lo-pass, Hi-pass, Talkbox, Wah Wah
  • CUTOFF: 0.00–100%
  • RESONANCE: 1.0–10.0%
  • LFO: red dot pulsates in set speed and depth
  • DEPTH: 0.00–100%
  • SPEED: 0.000000–30 Hz / 1/64–8 bars
  • WAVEFORM: Sinus, Square, Triangle, Saw, Inverted Saw, Random Square, Random Triangle
  • TEMPO SYNC: on/off

Flanger effect

FLANGER

Flanger effect.

  • RATE: 0.00000–20 hZ
  • DEPTH: 0.00–100%
  • FEEDBACK: 0.00–100%
  • STEREO: on/off

Freeverb effect

FREEVERB

Basic reverb.

  • SIZE: 0.0000–1.0
  • TONE: 0.000–1.00
  • DRY/WET: 0.00–100%
  • STEREO: on/off

Hi cut effect

HI-CUT

High cut filter.

  • FREQ: 50 Hz to 20.0 kHz
  • SLOPE: 0.50–10.0

Limiter effect

LIMITER

Lookahead limiter for mastering.

  • GAIN: -18.0–18.0 dB
  • ATTACK: 1.5–6.0 ms
  • RELEASE: 60–1000 ms

Lo cut effect

LO-CUT

Low cut filter.

  • FREQ: 50 Hz to 20.0 kHz
  • SLOPE: 0.50–10.0

Meter effect

METER

Various time and frequency domain information.

  • VU: VU meters and short term/momentary/integrated LUFS
  • SPECTRUM: visual spectrometer
  • SCOPE: zoomable oscilloscope

Mic effect

MIC

Allows feeding microphone directly into the mixer

  • GAIN: -18–18 dB

Noise gate effect

NOISE GATE

Cuts off audio going below a certain threshold.

  • THRESHOLD: -60–0 dB
  • ATTACK: 0.10–50 ms
  • HOLD: 5 ms to 2 sec
  • RELEASE: 3–1000 ms
  • SIDECHAIN: OFF, MIC, BUS A–D
  • REDUCTION: -90–0 dB

Phaser effect

PHASER

Phaser effect.

  • RATE: 0–10 Hz
  • DEPTH: 0–100%
  • FEEDBACK: 0–100%
  • STAGES: 2–16
  • STEREO: on/off

Pitch shift effect

PITCH SHIFT

Frequency domain pitch shifter.

  • PITCH: -12 to +12 semitones
  • BLEND: 0.0–100%
  • QUALITY: Low, Medium, High
  • STEREO: on/off

Ring mod effect

RING MOD

Ring modulator.

  • FREQ: 1.0 Hz to 8.00 kHz
  • MIX: 0.0–100%
  • DRIVE: 0.0–18.0 dB
  • LFO: red dot pulsates in set speed and depth
  • DEPTH: 0.0–100%
  • SPEED: 0.000000–30 Hz / 1/64–8 bars
  • STEREO: 0.00–100%
  • WAVEFORM: Sinus, Square, Triangle, Saw, Inverted Saw, Random Square, Random Triangle
  • TEMPO SYNC: on/off

Sidechain effect

SIDECHAIN

Sidechain compressor. Controls the volume of CHANEL by the volume of SOURCE

  • SOURCE: MIC, BUS A–D
  • THRESHOLD: -60–0 dB
  • RELEASE: 10.0–1000 ms
  • OUTPUT: -12.0–12 dB

Tape delay effect

TAPE DELAY

Delay effect simulating analog tape loops.

  • DELAY: 10.0 ms to 2.50 sec
  • FILTER: 300 Hz to 3.00 kHz
  • FEEDBACK: 0.000–120%
  • WOW AMOUNT: 0.00000–100%
  • WOW SPEED: 0.04–8.0 Hz
  • MIX: 0.00–100%

Tuner

TUNER

Instrument tuner. Picks up the channel signal.

Utility effect

UTILITY

Basic utilities and helpers for mixing.

  • CHANNEL: Stereo, Left, Right, L+R Mono
  • GAIN: -18.0–18.0 dB
  • FLIP PHASE: on/off

Warble effect

WARBLE

Emulates pitch wobble from a turntable or cassette.

  • VINYL: hold to pause audio
  • AMOUNT: 0–100%
  • WOW/FLUTTER: 0–100%
  • WOW SPEED: 0.05–5.0 Hz
  • FLUT SPEED: 5.0–25 Hz

9.3. Background Effects

Background effects are a nice way to make your Koala look unique and spice up screen recordings of your songs.

Background FX blinds

BLINDS

Slices the background into rotating lines creating an effect of window blinds.

  • SPEED: change the speed of rotation.
  • ZOOM: change the size of each blind.

Background FX Rings

RINGS

Slices the image into rings rotating in different directions.

  • SPEED: change the speed of rotation.
  • ZOOM: change the ring’s size.

Background FX Zoom Warp

ZOOM WARP

Continuously zooms, rotates and warps the background image.

  • SPEED: change the speed of rotation and zoom.
  • ZOOM: change the size on warped regions.

Background FX Zoom

ZOOM

Perpetually zooms the image from the center.

  • SPEED: changes the speed of the zoom effect.

Background FX Warpwarp

WARPWARP

Warps and bends the background.

  • AMOUNT: changes the amount of warping.
  • SPEED: changes the speed of warping.

Background FX TV

TV

Adds interlaced effect often used on CCTVs.

  • QUALITY: change the quality of interlace.

Background FX Kaleidodelic

KALEIDODELIC

Mixture of kaleidoscope and psychedelic effects.

  • NUMLOOPS: change the number of loops within each section.
  • SPEED: change the speed of looping.

Background FX Glitch

GLITCH

Computer screen glitch effect.

  • FREQUENCY: change the speed of glitching.
  • AMOUNT: change the amount of glitches on the screen.

Background FX Huey

HUEY

Splits the background into red, green and blue hues and shifts the overlays.

  • RGB: change the amount by which layers are shifted.
  • SPEED: change the speed of shifting.

Background FX Mirror

MIRROR

Mirrors and moves the image from the center in two halves.

  • SPEED: changes the speed of movement.
  • ANGLE: changes the angle of mirroring.

Background FX Scroll

SCROLL

Infinite scroll of the image in one direction.

  • SPEED: change the speed of scrolling.
  • ANGLE: change the angle of scrolling.

Background FX None

NONE

Static background image.